Hello,
The default when you replace a line card in a modular catalyst switch is that it removes the configuration for that line card.
I have a vague recollection of there being a command that you could enter to tell it not to do this.
Does anyone remember what that command is?
It isn't a huge deal to copy/paste the config and then add 'no shutdown' on every port but if you can avoid having to do that....
Thanks,
-Drew
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
The default when you replace a line card in a modular catalyst switch is that it removes the configuration for that line card.
I have a vague recollection of there being a command that you could enter to tell it not to do this.
Does anyone remember what that command is?
It isn't a huge deal to copy/paste the config and then add 'no shutdown' on every port but if you can avoid having to do that....
Thanks,
-Drew
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/