Mailing List Archive: nscrub routing mode setup problems

Hi all,

It is not clear to me how to configure nscrub when I use routing mode. I
am using one phy interface for both WAN and LAN side and I am using?
VLAN reforging to setup the output VLAN. I have also setup my routing
table via the API. What I don't understand is how/where to configure the
IP details in the interfaces. Since nscrub acts as a router, both input
and output interface need to have an IP address/mask.

Do I need to setup the IP address/mask on the linux interface and also
create a (logical) sub interface with vlan/ip address for the output?
(as I said i'm using one physical interface for both input and output)?

Thanx,

Spiros

_______________________________________________
Ntop-misc mailing list
Ntop-misc@listgateway.unipi.it
http://listgateway.unipi.it/mailman/listinfo/ntop-misc

Hi Spiros
yes you need to create vlan interfaces and assign IPs in linux, when you start nscrub it will detect them.

Alfredo

> On 6 Nov 2017, at 15:29, Spiros Papageorgiou <papage@noc.ntua.gr> wrote:
>
> Hi all,
>
> It is not clear to me how to configure nscrub when I use routing mode. I am using one phy interface for both WAN and LAN side and I am using VLAN reforging to setup the output VLAN. I have also setup my routing table via the API. What I don't understand is how/where to configure the IP details in the interfaces. Since nscrub acts as a router, both input and output interface need to have an IP address/mask.
>
> Do I need to setup the IP address/mask on the linux interface and also create a (logical) sub interface with vlan/ip address for the output (as I said i'm using one physical interface for both input and output)?
>
> Thanx,
>
> Spiros
>
>
> _______________________________________________
> Ntop-misc mailing list
> Ntop-misc@listgateway.unipi.it
> http://listgateway.unipi.it/mailman/listinfo/ntop-misc

Mailing List Archive

Mailing List Archive

Attached Files: