Hello,
I’m using nProbe from yesterday with my WanGuard Flow Sensor. There are logs on it like this: "Received flow from 142 seconds ago on interface "eth5". Adjusting flow delay from 141 to 142â€
I asked the WanGuard Support and I got the answer:
"The flow delay is the amount of time between the start time of the flow and the time the flow was received by the Sensor.
You can tune the flow export time (delay) in the flow exporter. “
So, the question is - what can I do to minimize this delay?
Regards,
Gabriel
I’m using nProbe from yesterday with my WanGuard Flow Sensor. There are logs on it like this: "Received flow from 142 seconds ago on interface "eth5". Adjusting flow delay from 141 to 142â€
I asked the WanGuard Support and I got the answer:
"The flow delay is the amount of time between the start time of the flow and the time the flow was received by the Sensor.
You can tune the flow export time (delay) in the flow exporter. “
So, the question is - what can I do to minimize this delay?
Regards,
Gabriel