This is on a brocade ICX6610
Is there a brocade equivalent of the cisco command show interface x/y capabilities ?
The show interface command gives me the below:
SSH@ETGUKHEXSAN02#sh interfaces e 1/3/1
10GigabitEthernet1/3/1 is up, line protocol is up
Port up for 18 days 19 hours 23 minutes 23 seconds
Hardware is 10GigabitEthernet, address is cc4e.24c2.efa0 (bia cc4e.24c2.efc3)
Interface type is 10Gig SFP+ Copper
Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, actual fdx
So I know it's a twinax cable (SFP+ copper - and I plugged it in)- but I was hoping to get more information ?
Any ideas?
Is there a brocade equivalent of the cisco command show interface x/y capabilities ?
The show interface command gives me the below:
SSH@ETGUKHEXSAN02#sh interfaces e 1/3/1
10GigabitEthernet1/3/1 is up, line protocol is up
Port up for 18 days 19 hours 23 minutes 23 seconds
Hardware is 10GigabitEthernet, address is cc4e.24c2.efa0 (bia cc4e.24c2.efc3)
Interface type is 10Gig SFP+ Copper
Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, actual fdx
So I know it's a twinax cable (SFP+ copper - and I plugged it in)- but I was hoping to get more information ?
Any ideas?