Mailing List Archive

After upgraded the routing code to:ASR12200.bin

monitor> show ver
Boot 12.01.00T405 Feb 26 2010 11:39:50 PST dob12100ba
Monitor 12.01.00T405 Feb 26 2010 11:39:50 PST dob12100ba (boot)
1.499 GHz Power PC processor MPC8572E (version 8021/0030) 599.9616 MHz bus
Monitor>

Monitor> show flash
Boot Flash Memory : AM29LV040B
Manufacture Code : 01
Device Code : 4f
Code Flash Memory : MT28F256J3
Manufacture Code : 89
Device Code : 1d
Monitor>

I have the following error in BP asm-1 BP-1

slot-asm, err BP App Timeout

Error: task_bringup_asm only 1/4 bps are ready on slot-asm, err BP App Timeout
ASM-1 BP-1 state: 5 BP not ready
ASM-1 BP-2 state: 8 Image Loaded
ASM-1 BP-3 state: 8 Image Loaded
ASM-1 BP-4 state: 8 Image Loaded
task_bringup_system: got msg, type 1, par0 00000008, par1 0000000a

ServerIronADX 1000#show asm
slot-asm Yes BP App Timeout BAD
bp 1: BP not ready
bp 2: Image Loaded
bp 3: Image Loaded
bp 4: Image Loaded


Error: task_bringup_asm only 0/4 bps are ready on slot-asm, err BP App Timeout
ASM-1 BP-1 state: 5 BP not ready
ASM-1 BP-2 state: 8 Image Loaded
ASM-1 BP-3 state: 8 Image Loaded
ASM-1 BP-4 state: 8 Image Loaded

*******************************************************************************************

ServerIronADX 1000#show ver
Copyright (c) 1996-2009 Brocade Communications Systems, Inc.
Boot Version 12.0.00T405 May 5 2009 17:32:40 PDT label: dob12000
Monitor Version 12.0.00T405 May 5 2009 17:32:40 PDT label: dob12000
System Version 12.0.00aT403 Jul 28 2009 17:12:17 PDT label: ASR12000a
AXP Version: 0.00 Dated: 2009/07/04 08:02:57
PAX Version: 0.0 Dated: 2009/01/23 11:46:57
MBRIDGE Version: 000b, Device ID # bebe

==========================================================================
Type: Stackable 16GC_2x10G
Serial #: E2SA42E01S
Part #: 84-1001008-01
SSL Card - Serial #: SA14100312
Version #: 13b626-020202-111d8036-00
==========================================================================
Active management module:
1499 MHz Power PC processor (version 00008021/0030) 599 MHz bus
1408 KB Boot flash
131072 KB Code flash
2048 MB DRAM
The system uptime is 2 minutes 7 seconds
The system started at 21:14:07, GMT+00, Tue May 06 2014

The system - boot source: primary, mode: warm start, soft reset, total resets:0

ServerIronADX 1000#

ServerIronADX 1000#show asm
slot-asm Yes BP App Timeout BAD
bp 1: BP not ready
bp 2: Image Loaded
bp 3: Image Loaded
bp 4: Image Loaded


Error: task_bringup_asm only 0/4 bps are ready on slot-asm, err BP App Timeout
ASM-1 BP-1 state: 5 BP not ready
ASM-1 BP-2 state: 8 Image Loaded
ASM-1 BP-3 state: 8 Image Loaded
ASM-1 BP-4 state: 8 Image Loaded
task_bringup_system: got msg, type 1, par0 00000008, par1 0000000a
Re-tuning TCAM interface
Using TCAM frequency 350

*******************************************************
copy process :
copy tftp flash 192.168.0.14 ASR12200.bin pri
................................................................................Done

Monitor> copy tftp flash 192.168.0.14 ASR12200.bin sec

................................................................................Done

************************************************************


if anyone have been there, please tell me what can i do the fix the issue. or is a hardware failure?

I'll appreciate all help .


Thanks

Carlos Alfaro Tech / Sales Support

Townsend Networks

35 Reed Blvd., Suite A Mill Valley, CA 94941

415-384-4208

mailto:carlos@townsendnetworks.com
_______________________________________________
foundry-nsp mailing list
foundry-nsp@puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp