Hello,
I play a little with drbd 0.5.8.1 on kernel 2.2.20 and
has some problems. I follow this scenario:
*) primary up, secondary up
*) primary down, secondary up, secondary becomes primary
*) on new primary I have WFConnection: Primary/Unknown
*) now _old_ primary goes up
*) I issue drbdsetup commands to setup my nb0 device
and get to SyncAll status, but after few seconds
I get on current primary:
drbd0: timeout detected! (pid=..)
drbd0: syncer send failed!!
drbd0: Syncer send failed!!
drbd0: Connection lost ..
drbd0: receiver exiting
and finally cr status set to Timeout.
Now I am unable to get of from Timeout status. Every
nbd related command hangs. Ideas?
--
David Hajek
hajek@example.com GSM: +420 604 352968
- ((lambda (foo) (bar foo)) (baz))
I play a little with drbd 0.5.8.1 on kernel 2.2.20 and
has some problems. I follow this scenario:
*) primary up, secondary up
*) primary down, secondary up, secondary becomes primary
*) on new primary I have WFConnection: Primary/Unknown
*) now _old_ primary goes up
*) I issue drbdsetup commands to setup my nb0 device
and get to SyncAll status, but after few seconds
I get on current primary:
drbd0: timeout detected! (pid=..)
drbd0: syncer send failed!!
drbd0: Syncer send failed!!
drbd0: Connection lost ..
drbd0: receiver exiting
and finally cr status set to Timeout.
Now I am unable to get of from Timeout status. Every
nbd related command hangs. Ideas?
--
David Hajek
hajek@example.com GSM: +420 604 352968
- ((lambda (foo) (bar foo)) (baz))