OK, I'm a little confused. (So what else is new :-)
I have CM 3.3.4 and Unity 4.0.2.
I have a remote site and a central site.
Both have a translation pattern for 0 for the receptionist at each
location.
No matter which site you're calling, if you get someone's v-mail and
dial 0 it goes to the remote sites receptionist. But if you just dial 0
from each location it goes to the correct receptionist. So it seems as
thou this is a Unity issue. Where does this get setup? Can I have two
receptions in Unity via 0?
PS. The central site receptionist is on a PBX and not using Unity for
v-mail.
TIA
Scott
I have CM 3.3.4 and Unity 4.0.2.
I have a remote site and a central site.
Both have a translation pattern for 0 for the receptionist at each
location.
No matter which site you're calling, if you get someone's v-mail and
dial 0 it goes to the remote sites receptionist. But if you just dial 0
from each location it goes to the correct receptionist. So it seems as
thou this is a Unity issue. Where does this get setup? Can I have two
receptions in Unity via 0?
PS. The central site receptionist is on a PBX and not using Unity for
v-mail.
TIA
Scott