Mailing List Archive: 7920 IP Phone - Switch and Access Point Setup

For those of you who are using the 7920 wireless IP phone in production,
could you tell me more about your switch and access point setup? We're
like most companies who put the access points on a different VLAN that
does not communicate with the corporate VLAN. I'd like to have the
access point be on the corporate VLAN, but not broadcast it's SSID and
use LEAP authentication. It's the most secure setup I can think of, but
if you have other secure setups you can share, please do. Also, on the
switch, would I setup a native and auxiliary VLAN?

Thanks,
Oliver

------------------------------------------------------------------------------
ATTENTION
The information contained in this message may be legally privileged and confidential. It is intended to be read only by the individual or entity to whom it is addressed or by their designee. If the reader of this message is not the intended recipient, you are on notice that any distribution of this message, in any form, is strictly prohibited. If you have received this message in error, please immediately notify the sender and/or Fenwick & West LLP by telephone at (650) 988-8500 and delete or destroy any copy of this message.
==============================================================================

What AP are you running? We have 1200's that are running IOS. The IOS is very easy to configure the second Vlan / SSID so that no one but your IP phones get on it. Just a push for the IOS, I didn't care for the Vxworks. We just upgraded when we got the 7920.

The switch is just setup as a trunk. We are using 3550's with inline power.

interface FastEthernet0/1
description AP by Willamette Room
switchport trunk encapsulation dot1q
switchport trunk native vlan 10
switchport mode trunk
mls qos trust cos
wrr-queue cos-map 1 0 1
wrr-queue cos-map 2 2 3
wrr-queue cos-map 3 4
wrr-queue cos-map 4 5 6 7
priority-queue out
spanning-tree portfast

Scott

-----Original Message-----
From: Oliver Rebollido [mailto:ORebollido@fenwick.com]
Sent: Monday, March 22, 2004 1:52 PM
To: cisco-voip@puck.nether.net
Subject: [cisco-voip] 7920 IP Phone - Switch and Access Point Setup

For those of you who are using the 7920 wireless IP phone in production, could you tell me more about your switch and access point setup? We're like most companies who put the access points on a different VLAN that does not communicate with the corporate VLAN. I'd like to have the access point be on the corporate VLAN, but not broadcast it's SSID and use LEAP authentication. It's the most secure setup I can think of, but if you have other secure setups you can share, please do. Also, on the switch, would I setup a native and auxiliary VLAN?

Thanks,
Oliver