Mailing List Archive: Modem-pool

Modem-pool

Jun 29, 2003, 10:42 PM

Post #1 of 3 (785 views)

Hi all,

I use an AS5300 with IOS 120-4.XJ4,

I have the following problem:

When I try to connect to the NAS I have the following error in my debug log:

00:04:03: to NEAT:(cid001A) EVENT_CALL_IDLE for slot0 ctlr4 chan5
00:04:03: cas_is_fax_service: cas_group=0, service=0
00:04:03: VDEV_ALLOCATE: failed to allocate a device from pool
System-def-Mpool
00:04:03: VDEV_ALLOCATE: failed to allocate a device from pool POOl-TEST
00:04:03: ERROR: CSM_RX_CAS_EVENT_FROM_NEAT:(cid001B): EVENT_CALL_DIAL_IN:
no modem is available.

Here is part of trhe config:

modem-pool POOL-TEST
pool-range 1-5

controller E1 4
framing NO-CRC4
clock source line secondary 4
cas-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
cas-custom 0
caller-digits 2

Does anyone know what's wrong?

Kind regards.

Re: Modem-pool [ In reply to ]

mitaylor at cisco

Jun 29, 2003, 11:52 PM

Post #2 of 3 (768 views)

Permalink

From memory, I have had a problem when I used the hyphen "-" in the modem
pool name...

Perhaps try renaming the modem pool to : 'POOL_TEST'...

Regards,
Mike Taylor

At 09:42 AM Monday 30/06/2003 +0400, Rivo Tahina RAZAFINDRATSIFA wrote:
>Hi all,
>
>I use an AS5300 with IOS 120-4.XJ4,
>
>I have the following problem:
>
>When I try to connect to the NAS I have the following error in my debug log:
>
>00:04:03: to NEAT:(cid001A) EVENT_CALL_IDLE for slot0 ctlr4 chan5
>00:04:03: cas_is_fax_service: cas_group=0, service=0
>00:04:03: VDEV_ALLOCATE: failed to allocate a device from pool
>System-def-Mpool
>00:04:03: VDEV_ALLOCATE: failed to allocate a device from pool POOl-TEST
>00:04:03: ERROR: CSM_RX_CAS_EVENT_FROM_NEAT:(cid001B): EVENT_CALL_DIAL_IN:
>no modem is available.
>
>
>Here is part of trhe config:
>
>modem-pool POOL-TEST
> pool-range 1-5
>
>controller E1 4
> framing NO-CRC4
> clock source line secondary 4
> cas-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
> cas-custom 0
> caller-digits 2
>
>
>
>Does anyone know what's wrong?
>
>Kind regards.
>
>_______________________________________________
>cisco-nas mailing list
>cisco-nas@puck.nether.net
>http://puck.nether.net/mailman/listinfo/cisco-nas

Cisco Systems,
Customer Support Engineer,
Asia Pacific Technical Assistance Centre,
Sydney, Australia
Ph: (+61 2) 8446 6044

Re: Modem-pool [ In reply to ]

mitaylor at cisco

Jun 30, 2003, 5:55 PM

Post #3 of 3 (766 views)

Permalink

I remember now, the problem I had was with IP address pools and the
'hyphen', so this is probably not relevant... sorry...

Moving on, the reasons I could see for modems not being allocated are:

1: modems are busy/locked up ('show modem' to make sure there are some
modems available.
2: If the config is looking for a specific incoming number, it is possible
that what is in the config doesn't match what the exchange is sending you
(e.g. if the number you are expecting is: 1 555 1234 567 and the switch
strips the leading digit, you'll end up receiving 555 1234 567).

Cheers,
Mike

At 04:52 PM Monday 30/06/2003 +1000, Michael Taylor (mitaylor) wrote:
> From memory, I have had a problem when I used the hyphen "-" in the modem
> pool name...
>
>Perhaps try renaming the modem pool to : 'POOL_TEST'...
>
>Regards,
>Mike Taylor
>
>At 09:42 AM Monday 30/06/2003 +0400, Rivo Tahina RAZAFINDRATSIFA wrote:
>>Hi all,
>>
>>I use an AS5300 with IOS 120-4.XJ4,
>>
>>I have the following problem:
>>
>>When I try to connect to the NAS I have the following error in my debug log:
>>
>>00:04:03: to NEAT:(cid001A) EVENT_CALL_IDLE for slot0 ctlr4 chan5
>>00:04:03: cas_is_fax_service: cas_group=0, service=0
>>00:04:03: VDEV_ALLOCATE: failed to allocate a device from pool
>>System-def-Mpool
>>00:04:03: VDEV_ALLOCATE: failed to allocate a device from pool POOl-TEST
>>00:04:03: ERROR: CSM_RX_CAS_EVENT_FROM_NEAT:(cid001B): EVENT_CALL_DIAL_IN:
>>no modem is available.
>>
>>
>>Here is part of trhe config:
>>
>>modem-pool POOL-TEST
>> pool-range 1-5
>>
>>controller E1 4
>> framing NO-CRC4
>> clock source line secondary 4
>> cas-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
>> cas-custom 0
>> caller-digits 2
>>
>>
>>
>>Does anyone know what's wrong?
>>
>>Kind regards.
>>
>>_______________________________________________
>>cisco-nas mailing list
>>cisco-nas@puck.nether.net
>>http://puck.nether.net/mailman/listinfo/cisco-nas
>
>Cisco Systems,
>Customer Support Engineer,
>Asia Pacific Technical Assistance Centre,
>Sydney, Australia
>Ph: (+61 2) 8446 6044
>
>_______________________________________________
>cisco-nas mailing list
>cisco-nas@puck.nether.net
>http://puck.nether.net/mailman/listinfo/cisco-nas

Cisco Systems,
Customer Support Engineer,
Asia Pacific Technical Assistance Centre,
Sydney, Australia
Ph: (+61 2) 8446 6044