I'm trying to enable an interval between failed auth attempts, which has to be
configured on the client modem.
I tried the "dialer redial" command:
int dialer 1
dialer redial interval 60 attempts 3 re-enable 300
but the problem is that this redial interval isn't working for ppp auth
failures, because it doesn't count them.
Di2 - dialer type = DIALER PROFILE
Idle timer (300 secs), Fast idle timer (30 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
Number of active calls = 0
Dial String Successes Failures Last DNIS Last status
xxxxxxxxxx 96 0 00:00:10 successful Default
So is there a way to delay the redial after a ppp auth failure?
--
Tassos
_______________________________________________
cisco-nas mailing list
cisco-nas@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nas
configured on the client modem.
I tried the "dialer redial" command:
int dialer 1
dialer redial interval 60 attempts 3 re-enable 300
but the problem is that this redial interval isn't working for ppp auth
failures, because it doesn't count them.
Di2 - dialer type = DIALER PROFILE
Idle timer (300 secs), Fast idle timer (30 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
Number of active calls = 0
Dial String Successes Failures Last DNIS Last status
xxxxxxxxxx 96 0 00:00:10 successful Default
So is there a way to delay the redial after a ppp auth failure?
--
Tassos
_______________________________________________
cisco-nas mailing list
cisco-nas@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nas