Okay, here it is, the fix:
Linux Virtual Home Page HOWTO:
i) Get linux kernel 1.2.x ( >=5 recommended) and compile with the
following options:
CONFIG_MODVERSIONS=y
CONFIG_NETDEVICES=y
# CONFIG_DUMMY is not set ( say no when configuring )
ii) make dep ; make zImage ; make modules ; make modules_install
iii) cp /usr/src/linux/arch/i386/boot/zImage /vmlinuz
iv) rdev -R /vmlinuz 1 ; lilo
v) reboot system
vi) insmod -o dummy0 /lib/modules/1.2.x/net/dummy.o
vii) ifconfig dummy0 200.200.200.50 up
NOTE: Make sure the IP address you choice is a valid one, and not
being used.
viii) arp -s <ethernet address> 200.200.200.50
netmask 255.255.255.255 pub
NOTE: the ethernet address of your ethernet card can be found if you
type ifconfig eth0. First line, there are 6 hex numbers sepearted
by ':'. Use that.
ix) route add 200.200.200.50 dummy0
x) Add <virtual host 200.200.200.50> ..... < /virtualhost>
to your httpd.conf file.
xi) Add 200.200.200.50 to your /etc/hosts or DNS database files.
xii) Repeat from process one with dummy1 if so desired.
Is anyone keeping a HOWTO file? Please sent to it, so I can change the
above into the normal format that has been used.
Thanx.
<Aram>
P.S. The important thing was the 'netmask' variable on the arp line.
--
Aram W. Mirzadeh, MIS Manager, Qosina Corporation
http://www.qosina.com/~awm/, awm@qosina.com
Linux Virtual Home Page HOWTO:
i) Get linux kernel 1.2.x ( >=5 recommended) and compile with the
following options:
CONFIG_MODVERSIONS=y
CONFIG_NETDEVICES=y
# CONFIG_DUMMY is not set ( say no when configuring )
ii) make dep ; make zImage ; make modules ; make modules_install
iii) cp /usr/src/linux/arch/i386/boot/zImage /vmlinuz
iv) rdev -R /vmlinuz 1 ; lilo
v) reboot system
vi) insmod -o dummy0 /lib/modules/1.2.x/net/dummy.o
vii) ifconfig dummy0 200.200.200.50 up
NOTE: Make sure the IP address you choice is a valid one, and not
being used.
viii) arp -s <ethernet address> 200.200.200.50
netmask 255.255.255.255 pub
NOTE: the ethernet address of your ethernet card can be found if you
type ifconfig eth0. First line, there are 6 hex numbers sepearted
by ':'. Use that.
ix) route add 200.200.200.50 dummy0
x) Add <virtual host 200.200.200.50> ..... < /virtualhost>
to your httpd.conf file.
xi) Add 200.200.200.50 to your /etc/hosts or DNS database files.
xii) Repeat from process one with dummy1 if so desired.
Is anyone keeping a HOWTO file? Please sent to it, so I can change the
above into the normal format that has been used.
Thanx.
<Aram>
P.S. The important thing was the 'netmask' variable on the arp line.
--
Aram W. Mirzadeh, MIS Manager, Qosina Corporation
http://www.qosina.com/~awm/, awm@qosina.com