Hi All,
I am trying to run Xen on ARM v4.3.3, on ARM Fast Models for the versatile express platform, but I have run into some errors.
I have compiled the Linux kernel 3.8 rc3 as a dom0 image using linaro tool chain and the config parameters as mentioned here http://xenbits.xen.org/people/sstabellini/config
I have also exported the the variable CONFIG_DTB_FILE to the location of the device tree file which is taken from http://xenbits.xen.org/gitweb/?p=people/sstabellini/device-trees.git;a=blob_plain;f=vexpress-v2p-ca15-tc1.dtb;hb=HEAD while compiling Xen
I am getting No Valid device tree error as shown below
Trying ::1...
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
- UART enabled -
- CPU 00000000 booting -
- Started in Secure state -
- Entering Hyp mode -
- Zero BSS -
- Setting up control registers -
- Turning on paging -
- Ready -
No valid device tree
Regards
Shubham Khandelwal
I am trying to run Xen on ARM v4.3.3, on ARM Fast Models for the versatile express platform, but I have run into some errors.
I have compiled the Linux kernel 3.8 rc3 as a dom0 image using linaro tool chain and the config parameters as mentioned here http://xenbits.xen.org/people/sstabellini/config
I have also exported the the variable CONFIG_DTB_FILE to the location of the device tree file which is taken from http://xenbits.xen.org/gitweb/?p=people/sstabellini/device-trees.git;a=blob_plain;f=vexpress-v2p-ca15-tc1.dtb;hb=HEAD while compiling Xen
I am getting No Valid device tree error as shown below
Trying ::1...
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
- UART enabled -
- CPU 00000000 booting -
- Started in Secure state -
- Entering Hyp mode -
- Zero BSS -
- Setting up control registers -
- Turning on paging -
- Ready -
No valid device tree
Regards
Shubham Khandelwal