Hi all
Just wanted to check if anyone knew whether the configuration that's already applied to interfaces stays valid after a line card is swapped with another.
In this example I am wanting to swap a "BR-MLX-10Gx24-DM 24-port 10GbE Module" with a "NI-MLX-10Gx8-M 8-port 10GbE (M) Module" but I want the relevant configuration for each port to stay exactly the same.
I am assuming so, but thought best to check before proceeding. I can assume we'd only run in to issues where moving to a card with less interfaces (e.g. as the startup-config was applied, no matching interface for eth1/9 on an 8-port card would be found).
Kind Regards,
Josh Farrelly
Infrastructure Architect, ICTS.
Manukau Institute of Technology
Just wanted to check if anyone knew whether the configuration that's already applied to interfaces stays valid after a line card is swapped with another.
In this example I am wanting to swap a "BR-MLX-10Gx24-DM 24-port 10GbE Module" with a "NI-MLX-10Gx8-M 8-port 10GbE (M) Module" but I want the relevant configuration for each port to stay exactly the same.
I am assuming so, but thought best to check before proceeding. I can assume we'd only run in to issues where moving to a card with less interfaces (e.g. as the startup-config was applied, no matching interface for eth1/9 on an 8-port card would be found).
Kind Regards,
Josh Farrelly
Infrastructure Architect, ICTS.
Manukau Institute of Technology