I moved my mythtv backend back to the original NUC now that I have the NUC
fan repaired. I rsync'ed my files back, restored the database, and ran
mythtv-setup on my NUC and saw the IP address had changed so I selected the
new one.
I finished testing out the system. Later I saw that on reboot the NUC was
back on Ethernet and not wifi so I disabled WiFi. I went back into
mythtv-setup and tried to change the IP again, but now mythtv-setup has a
segment fault.
Visually, mythtv-setup starts. shows the menu and then that disappears and
you have the message boxes pop up asking if you want to start the backend
and run mythfilldatabase.
I need to figure this out, so any help is appreciated.
Jim A
fan repaired. I rsync'ed my files back, restored the database, and ran
mythtv-setup on my NUC and saw the IP address had changed so I selected the
new one.
I finished testing out the system. Later I saw that on reboot the NUC was
back on Ethernet and not wifi so I disabled WiFi. I went back into
mythtv-setup and tried to change the IP again, but now mythtv-setup has a
segment fault.
Visually, mythtv-setup starts. shows the menu and then that disappears and
you have the message boxes pop up asking if you want to start the backend
and run mythfilldatabase.
I need to figure this out, so any help is appreciated.
Jim A