Mailing List Archive: V92 modemcap for NP

> We use the following modemcap for our V92 MICA (2.9.4.0)

> modemcap entry
> MICA_2940:MSC=&F&D2S54=16584S0=0S29=12S21=15S62=8S63=3S34=18000S40=10S10=50

MICA docs:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/5300/sw_conf/sw_ports/at_set/atcmnds.htm

Translating:

S54=16584
16384 - enable V.92/V.44 on IOS that doesn't support capabilities exchange
256 - add 0.5 to the SQ threshold (default)
32 - PC-tel workaround
8 - enable power control (default)
4 - 4-point training
S0=0 autoanswer after 0 sec.
S29=12 V.92 automode
S21=15 V.44, V.42bis, MNP5 enabled
S62=8 Allow V.92 MoH for up to 4 minutes
S63=3 Enable QC with ANSpcm @ -12dBm
S34=18000 Fall forward after 3 good minutes
S40=10 Disconnect after 10 consecutive retrains
S10=50 Hangup after 5 sec carrier loss

> Is the following modemcap the right one for NP (0.8.3.0), if we want to have the same
> modem behaviour?

> modemcap entry NEXTPORT-V92:MSC=&F&D2S29=12S62=8

NextPort docs: http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/as5400/sw_conf/atnextpt.htm

Leaving out the default settings and the ones that don't apply to
NextPort, I'd use:

&FS0=0S62=8

If you want NextPort to receive at a more conservative rate (not normally
needed; NextPort does a good job by default of selecting its receive
rate), set S76 to 1, 2 or 3.

Aaron

---

> --
> ***********************************
> Chatzithomaoglou Anastasios
> Network Design & Operations Center
> FORTHnet S.A.
> <achatz@forthnet.gr>
> ***********************************

> _______________________________________________
> cisco-nas mailing list
> cisco-nas@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nas