Is there a known problem with this ios and Windows clients?
I did an upgrade from 12.2(XA5) to these 2 ios, and both seem to cause
some problems with mostly win98 users. With the previous release (XA) everything
seemed to work fine.
Now a lot of users get microsoft "error 629" while "verifying username & password...".
The modems negotiate fine but the ppp doesn't seem to start at all.
While i had the following debugs enabled, only the modem debug showed some output.
PPP:
PPP detailed event debugging is on
PPP protocol errors debugging is on
PPP protocol negotiation debugging is on
PPP packet display debugging is on
Modem Management:
Modem Management Call Switching Module debugging is on
---------------------------------------------------------
These are the modem logs:
Sep 29 17:17:54: Modem State event:
State: Call Setup
Sep 29 17:17:54: Modem State event:
State: Connect
Sep 29 17:17:54: Modem State event:
State: V.8bis Exchange
Sep 29 17:17:54: Modem State event:
State: Link
Sep 29 17:18:06: Modem State event:
State: Ranging
Sep 29 17:18:06: Modem State event:
State: Half Duplex Train
Sep 29 17:18:06: Modem State event:
State: Train Up
Sep 29 17:18:18: Modem State event:
State: EC Negotiating
Sep 29 17:18:18: Modem State event:
State: Steady
Sep 29 17:18:18: RS232 event: RTS, DTR, CTS, DCD
Sep 29 17:18:18: Static event:
Connect Protocol: LAP-M
Compression: V.42bis both
Connected Standard: V.90
TX,RX Symbol Rate: 8000, 3200
TX,RX Carrier Frequency: 0, 1829
TX,RX Trellis Coding: 0, 16
Frequency Offset: 0.0 Hz
Round Trip Delay: 10 msecs
TX,RX Bit Rate: 52000, 31200
Robbed Bit Signalling (RBS) pattern: 0
Digital Pad: None, Digital Pad Compensation: Enabled
QC Exchange: No QC Requested
TX,RX Negotiated String Length: 32, 32
DC TX,RX Negotiated Codewords: 2048, 2048
DC TX,RX Negotiated History Size: 0, 0
Diagnostic Code: 00 00 00 00 00 00 00 00
V.92 Status: V.92 not negotiated
Sep 29 17:18:18: Dynamic event:
Sq Value: 3
Signal Noise Ratio: 38 dB
Receive Level: -17 dBm
Phase Jitter Frequency: 0.0 Hz
Phase Jitter Level: 0 degrees
Far End Echo Level: -37 dBm
Phase Roll: 0.0 Hz
Total Retrains: 0
EC Retransmission Count: 0
Characters transmitted, received: 42, 0
General Portware Information: 22
PPP/SLIP packets transmitted, received: 0, 0
PPP/SLIP packets received (BAD/ABORTED): 0
EC packets transmitted, received OK: 1, 0
Moving Average of EC packets (Received BAD/ABORTED): 0
V110/PIAFS frames received bad: 0
V110/PIAFS frames received good: 0
V110/PIAFS frames transmitted: 0
V110/PIAFS sync lost: 0
PIAFS RTF: 0
Total Speedshifts: 0
Total MOH Time: 0 secs
Current MOH Time: 0 secs
MOH Status: Modem is Not on Hold
MOH Count: 0
MOH Request Count: 0
Retrains due to Call Waiting: 0
DC Encoder,Decoder State: stat not supported/stat not supported
DC TX,RX Compression Ratio: 0.0:1, 0.0:1
DC TX,RX Dictionary Reset Count: 0, 0
Diagnostic Code: 00 00 00 00 00 00 00 00
Sep 29 17:18:30: RS232 event: noRTS, DTR, CTS, DCD
Sep 29 17:18:30: RS232 event: noRTS, noDTR, CTS, DCD
Sep 29 17:18:30: RS232 event: noRTS, DTR, CTS, DCD
Sep 29 17:18:30: RS232 event: RTS, DTR, CTS, DCD
Sep 29 17:18:30: Modem State event:
State: Terminate
Sep 29 17:18:30: RS232 event: RTS, DTR, CTS, noDCD
Sep 29 17:18:30: Modem State event:
State: Idle
Sep 29 17:18:30: End Connect event:
Call Timer: 29 secs
Disconnect Reason Info: (0xDF03)
Type (=6 ): Tx (host to line) data flushing - OK
Class (=31): Requested by host
Reason (=3 ): DTR dropped
Total Retrains: 0
EC Retransmission Count: 1
Characters transmitted, received: 116, 39
General Portware Information: 22
PPP/SLIP packets transmitted, received: 0, 0
PPP/SLIP packets received (BAD/ABORTED): 0
EC packets transmitted, received OK: 12, 3
Moving Average of EC packets (Received BAD/ABORTED): 0
V110/PIAFS frames received bad: 0
V110/PIAFS frames received good: 0
V110/PIAFS frames transmitted: 0
V110/PIAFS sync lost: 0
TX,RX Bit Rate: 52000, 31200
Total Speedshifts: 0
Total MOH Time: 0 secs
Current MOH Time: 0 secs
MOH Status: Modem is Not on Hold
MOH Count: 0
MOH Request Count: 0
Retrains due to Call Waiting: 0
DC Encoder,Decoder State: stat not supported/stat not supported
DC TX,RX Compression Ratio: 0.0:1, 0.0:1
DC TX,RX Dictionary Reset Count: 0, 0
Diagnostic Code: 00 00 00 00 00 00 00 00
Sep 29 17:18:30: Link Rate event:
MICA modem rate of service information:
connect range 51968 to 52224 for 9 sec.
--
***********************************
Chatzithomaoglou Anastasios
Network Design & Operations Center
FORTHnet S.A.
<achatz@forthnet.gr>
***********************************
I did an upgrade from 12.2(XA5) to these 2 ios, and both seem to cause
some problems with mostly win98 users. With the previous release (XA) everything
seemed to work fine.
Now a lot of users get microsoft "error 629" while "verifying username & password...".
The modems negotiate fine but the ppp doesn't seem to start at all.
While i had the following debugs enabled, only the modem debug showed some output.
PPP:
PPP detailed event debugging is on
PPP protocol errors debugging is on
PPP protocol negotiation debugging is on
PPP packet display debugging is on
Modem Management:
Modem Management Call Switching Module debugging is on
---------------------------------------------------------
These are the modem logs:
Sep 29 17:17:54: Modem State event:
State: Call Setup
Sep 29 17:17:54: Modem State event:
State: Connect
Sep 29 17:17:54: Modem State event:
State: V.8bis Exchange
Sep 29 17:17:54: Modem State event:
State: Link
Sep 29 17:18:06: Modem State event:
State: Ranging
Sep 29 17:18:06: Modem State event:
State: Half Duplex Train
Sep 29 17:18:06: Modem State event:
State: Train Up
Sep 29 17:18:18: Modem State event:
State: EC Negotiating
Sep 29 17:18:18: Modem State event:
State: Steady
Sep 29 17:18:18: RS232 event: RTS, DTR, CTS, DCD
Sep 29 17:18:18: Static event:
Connect Protocol: LAP-M
Compression: V.42bis both
Connected Standard: V.90
TX,RX Symbol Rate: 8000, 3200
TX,RX Carrier Frequency: 0, 1829
TX,RX Trellis Coding: 0, 16
Frequency Offset: 0.0 Hz
Round Trip Delay: 10 msecs
TX,RX Bit Rate: 52000, 31200
Robbed Bit Signalling (RBS) pattern: 0
Digital Pad: None, Digital Pad Compensation: Enabled
QC Exchange: No QC Requested
TX,RX Negotiated String Length: 32, 32
DC TX,RX Negotiated Codewords: 2048, 2048
DC TX,RX Negotiated History Size: 0, 0
Diagnostic Code: 00 00 00 00 00 00 00 00
V.92 Status: V.92 not negotiated
Sep 29 17:18:18: Dynamic event:
Sq Value: 3
Signal Noise Ratio: 38 dB
Receive Level: -17 dBm
Phase Jitter Frequency: 0.0 Hz
Phase Jitter Level: 0 degrees
Far End Echo Level: -37 dBm
Phase Roll: 0.0 Hz
Total Retrains: 0
EC Retransmission Count: 0
Characters transmitted, received: 42, 0
General Portware Information: 22
PPP/SLIP packets transmitted, received: 0, 0
PPP/SLIP packets received (BAD/ABORTED): 0
EC packets transmitted, received OK: 1, 0
Moving Average of EC packets (Received BAD/ABORTED): 0
V110/PIAFS frames received bad: 0
V110/PIAFS frames received good: 0
V110/PIAFS frames transmitted: 0
V110/PIAFS sync lost: 0
PIAFS RTF: 0
Total Speedshifts: 0
Total MOH Time: 0 secs
Current MOH Time: 0 secs
MOH Status: Modem is Not on Hold
MOH Count: 0
MOH Request Count: 0
Retrains due to Call Waiting: 0
DC Encoder,Decoder State: stat not supported/stat not supported
DC TX,RX Compression Ratio: 0.0:1, 0.0:1
DC TX,RX Dictionary Reset Count: 0, 0
Diagnostic Code: 00 00 00 00 00 00 00 00
Sep 29 17:18:30: RS232 event: noRTS, DTR, CTS, DCD
Sep 29 17:18:30: RS232 event: noRTS, noDTR, CTS, DCD
Sep 29 17:18:30: RS232 event: noRTS, DTR, CTS, DCD
Sep 29 17:18:30: RS232 event: RTS, DTR, CTS, DCD
Sep 29 17:18:30: Modem State event:
State: Terminate
Sep 29 17:18:30: RS232 event: RTS, DTR, CTS, noDCD
Sep 29 17:18:30: Modem State event:
State: Idle
Sep 29 17:18:30: End Connect event:
Call Timer: 29 secs
Disconnect Reason Info: (0xDF03)
Type (=6 ): Tx (host to line) data flushing - OK
Class (=31): Requested by host
Reason (=3 ): DTR dropped
Total Retrains: 0
EC Retransmission Count: 1
Characters transmitted, received: 116, 39
General Portware Information: 22
PPP/SLIP packets transmitted, received: 0, 0
PPP/SLIP packets received (BAD/ABORTED): 0
EC packets transmitted, received OK: 12, 3
Moving Average of EC packets (Received BAD/ABORTED): 0
V110/PIAFS frames received bad: 0
V110/PIAFS frames received good: 0
V110/PIAFS frames transmitted: 0
V110/PIAFS sync lost: 0
TX,RX Bit Rate: 52000, 31200
Total Speedshifts: 0
Total MOH Time: 0 secs
Current MOH Time: 0 secs
MOH Status: Modem is Not on Hold
MOH Count: 0
MOH Request Count: 0
Retrains due to Call Waiting: 0
DC Encoder,Decoder State: stat not supported/stat not supported
DC TX,RX Compression Ratio: 0.0:1, 0.0:1
DC TX,RX Dictionary Reset Count: 0, 0
Diagnostic Code: 00 00 00 00 00 00 00 00
Sep 29 17:18:30: Link Rate event:
MICA modem rate of service information:
connect range 51968 to 52224 for 9 sec.
--
***********************************
Chatzithomaoglou Anastasios
Network Design & Operations Center
FORTHnet S.A.
<achatz@forthnet.gr>
***********************************