Hi
I'm trying to run telemetry on IOS XE (Catalyst 9300) but without lack.
My config:
test#sh run | sec tele
telemetry ietf subscription 1
encoding encode-kvgpb
filter xpath
/process-cpu-ios-xe-oper:cpu-usage/cpu-utilization/five-seconds
source-address 10.0.0.147
source-vrf Mgmt-vrf
stream yang-push
update-policy periodic 500
receiver ip address 10.0.3.16 12345 protocol grpc-tcp
But it's not working:
#show telemetry ietf subscription all
The process for the command is not responding or is otherwise unavailable
Any ideas ?
Running IOS XE 17.02.01
Rob
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
I'm trying to run telemetry on IOS XE (Catalyst 9300) but without lack.
My config:
test#sh run | sec tele
telemetry ietf subscription 1
encoding encode-kvgpb
filter xpath
/process-cpu-ios-xe-oper:cpu-usage/cpu-utilization/five-seconds
source-address 10.0.0.147
source-vrf Mgmt-vrf
stream yang-push
update-policy periodic 500
receiver ip address 10.0.3.16 12345 protocol grpc-tcp
But it's not working:
#show telemetry ietf subscription all
The process for the command is not responding or is otherwise unavailable
Any ideas ?
Running IOS XE 17.02.01
Rob
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/