Hello Everybody!
Have to complain about SNMP... *GRIN*... in IOS .. *GRIN*.. ...again..
I had to upgrade to 12.2.mainline because, of full duplex support on PA-4E (7200)... *GRIN*..
Currently running on 12.2.10b and the problem is here also....
Box have ATM/FE/ETH/E1 interfaces.. and here comes the tale:
In OLD-CISCO-INTERFACES-MIB, there is an description for each interface locIfDescr
When I walk over this OID .1.3.6.1.4.1.9.2.2.1.1.28 , I can see only first 45 interfaces....and then nothing... I have a lot of ATM
subinf and E1 group interfaces.. On another BOX, where for the same reasons I have to run same software, I have only PA-4E and 8
ports X.21 interfaces.. Together, there is more interfaces then 45. If I do same SNMP walk, I can see all of them...
Any help?... over bug listing, no approp. bug found ... Previous IOS 12.0.21S....
Cheers
Alex
Have to complain about SNMP... *GRIN*... in IOS .. *GRIN*.. ...again..
I had to upgrade to 12.2.mainline because, of full duplex support on PA-4E (7200)... *GRIN*..
Currently running on 12.2.10b and the problem is here also....
Box have ATM/FE/ETH/E1 interfaces.. and here comes the tale:
In OLD-CISCO-INTERFACES-MIB, there is an description for each interface locIfDescr
When I walk over this OID .1.3.6.1.4.1.9.2.2.1.1.28 , I can see only first 45 interfaces....and then nothing... I have a lot of ATM
subinf and E1 group interfaces.. On another BOX, where for the same reasons I have to run same software, I have only PA-4E and 8
ports X.21 interfaces.. Together, there is more interfaces then 45. If I do same SNMP walk, I can see all of them...
Any help?... over bug listing, no approp. bug found ... Previous IOS 12.0.21S....
Cheers
Alex